简介

Replacing the RAM (Random-Access Memory) is one of the easiest operations to perform on this device. The only tools you need are plastic opening tools and a Phillips screwdriver to remove the back panel.

  1. Remove the grey scuff guard at the bottom of the PC by pressing down on it, and pulling it away. Lift the hinge and remove the grey rubber tabs on either side of the PC’s model information. Remove the two 7.62mm Phillips #1 screws beneath the rubber tabs under the hinge and the four 7.62mm Phillips #1 screws where the scuff guard was removed.
    • Remove the grey scuff guard at the bottom of the PC by pressing down on it, and pulling it away.

    • Lift the hinge and remove the grey rubber tabs on either side of the PC’s model information.

    • Remove the two 7.62mm Phillips #1 screws beneath the rubber tabs under the hinge and the four 7.62mm Phillips #1 screws where the scuff guard was removed.

    • Remove the two 4.74mm Phillips #1 screws under the hinge (near the hinge joints) and a 4.74mm Phillips #1 screw under the handle.

  2. Use 1-2 plastic opening tools or nylon spudgers to firmly pry open the back panel. We recommend that you start prying the panel where the scuff guard was removed. Prying the back panel will cause loud popping noises. This is just the sound of the clips that hold the back panel to the PC popping off.
    • Use 1-2 plastic opening tools or nylon spudgers to firmly pry open the back panel.

    • We recommend that you start prying the panel where the scuff guard was removed.

    • Prying the back panel will cause loud popping noises. This is just the sound of the clips that hold the back panel to the PC popping off.

    • Using excess force while prying can break the clips that hold the back panel and can damage the ports on the side of the PC.

  3. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Disconnect the three cables connecting the back panel ports to the motherboard. Flip up the locking latch holding the two ribbon cables with a plastic opening tool and pull the cables out. Gently wiggle the third connector out of its socket.
    • Disconnect the three cables connecting the back panel ports to the motherboard.

    • Flip up the locking latch holding the two ribbon cables with a plastic opening tool and pull the cables out.

    • Gently wiggle the third connector out of its socket.

  5. Peel off the tape attaching the metal enclosure to the heat sink. Lift the metal enclosure off of the motherboard.
    • Peel off the tape attaching the metal enclosure to the heat sink.

    • Lift the metal enclosure off of the motherboard.

  6. Pull the jaws of the white plastic frame apart. This will pop the front of the RAM up. Gently lift the front edge of the RAM. Pull the RAM out and up.
    • Pull the jaws of the white plastic frame apart. This will pop the front of the RAM up.

    • Gently lift the front edge of the RAM.

    • Pull the RAM out and up.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Elliot Kane

于2018年04月17日注册

315 信誉积分

创作了2篇指南

团队

Cal Poly, Team S17-G5, Livingston Spring 2018 Cal Poly, Team S17-G5, Livingston Spring 2018 的会员

CPSU-LIVINGSTON-S18S17G5

4 名成员

创作了8篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 16

总计 213