跳转到主内容

简介

Proper visibility when driving is crucial to safe transportation. In rain and snow, suitable windshield wipers will help ensure clear visibility. Use this guide to realign the front windshield wiper arm on a 2008 Subaru Impreza. In a few easy steps, this guide will get you back on the road to safer driving.

工具

配件

没有特定配件。

  1. To begin, pop open your hood for best access.
    • To begin, pop open your hood for best access.

  2. There will be a rectangular bolt cover on the end of the wiper arm.
    • There will be a rectangular bolt cover on the end of the wiper arm.

    • To remove this cover, grab each side with your fingers and pull upward.

    • It may help to wedge your fingernails underneath the cover piece.

  3. After removing the bolt cover, you will find the bolt that holds the wiper arm onto the vehicle.
    • After removing the bolt cover, you will find the bolt that holds the wiper arm onto the vehicle.

  4. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
  5. Loosen the bolt with the socket wrench just enough to be able to move the arm up and down the windshield.
    • Loosen the bolt with the socket wrench just enough to be able to move the arm up and down the windshield.

    • To loosen with the wrench, place the socket directly on top of the bolt and turn counter clockwise.

  6. Adjust the windshield wiper arm such that it is in the proper resting position.
    • Adjust the windshield wiper arm such that it is in the proper resting position.

  7. There should be approximately 2 inches of space between the bottom of the windshield and the wiper in proper resting position.
    • There should be approximately 2 inches of space between the bottom of the windshield and the wiper in proper resting position.

  8. Once the arm is in correct position, tighten the same bolt at the bottom of the arm to keep the wiper in place.
    • Once the arm is in correct position, tighten the same bolt at the bottom of the arm to keep the wiper in place.

    • To tighten the bolt, place the socket directly on top of the bolt and turn in clockwise position until you are no longer able to turn.

  9. Place the bolt cover back over the bolt and push it down into clipped position.
    • Place the bolt cover back over the bolt and push it down into clipped position.

  10. Close the hood of the vehicle. Your windshield wiper should now be in the correct position.
    • Close the hood of the vehicle. Your windshield wiper should now be in the correct position.

结论

This guide will allow you to adjust both of the front windshield wipers. To realign the passenger side wiper, follow these steps in correct order.

另外一个人完成了本指南。

Brianna Koski

于2016年03月22日注册

128 信誉积分

撰写一个指南

团队

Michigan Tech, Team 1-15, Lauer Spring 2016 Michigan Tech, Team 1-15, Lauer Spring 2016 的会员

MTU-LAUER-S16S1G15

1 名成员

创作了1篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 28

总计 2,262