Skip to main content

介绍

This is a guide on how to install new LED bulbs for the truck high mount brake/tail lamp demonstrated on a Chevy Silverado. Since there are screws you will need to remove, make sure you have a Philips screwdriver before you get started. You have the option of swapping out your truck bed light under the clear lens or the reverse lights under the red lens.

  1. Take the Philips screwdriver and remove two Philips head screws on both sides of the high mount brake lamp. Be sure to store the two Philips screws in a safe place so they don't get lost. Be sure to store the two Philips screws in a safe place so they don't get lost.
    • Take the Philips screwdriver and remove two Philips head screws on both sides of the high mount brake lamp.

    • Be sure to store the two Philips screws in a safe place so they don't get lost.

  2. Pull out the truck high mount brake/tail light housing. We recommend you pull out the housing with both hands so you don't break the water tight seal.
    • Pull out the truck high mount brake/tail light housing.

    • We recommend you pull out the housing with both hands so you don't break the water tight seal.

    • If in the event that you happen you break it, you may have some water leak issues so you would have to fix the high mount brake/tail lamp housing with some glue.

  3. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  4. Remove the stock bulbs from its socket. Remove the stock bulbs from its socket. Remove the stock bulbs from its socket.
    • Remove the stock bulbs from its socket.

  5. Replace with the LED bulb.
    • Replace with the LED bulb.

    • Test your new LED truck high mount brake lamps to make sure everything works.

    • If the LED lights don't light up, check the polarity by flipping the bulbs 180 degrees.

  6. Put back the light housing and screw in the two Philips screws. Put back the light housing and screw in the two Philips screws. Put back the light housing and screw in the two Philips screws.
    • Put back the light housing and screw in the two Philips screws.

结论

Test and enjoy your new LED truck high mount brake/tail replacement lights.

2等其他人完成本指南。

Eric Wu

于2015年01月21日注册

2,802 Reputation

创作了23篇指南

2 Comments

The problem is there are no screws to remove.

richard - 回复

there are no screws to remove on my 3rd light I can’t change the bulb

richard - 回复

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 18

All Time: 2,808