修复你的物品 社区 商店

1998-2002 Honda Accord Distributor Cap Replacement

简介

Use this guide to replace your 4-cylinder Honda Accord's distributor cap. This specific guide was created for a non-VTEC F23A5 engine, but other 4-cylinder Honda engines will be similar enough to follow the same basic steps

你所需要的

  1. 1998-2002 Honda Accord Distributor Cap Replacement, Distributor Cap: 步骤 1 中的图像 1，3 1998-2002 Honda Accord Distributor Cap Replacement, Distributor Cap: 步骤 1 中的图像 2，3 1998-2002 Honda Accord Distributor Cap Replacement, Distributor Cap: 步骤 1 中的图像 3，3

    • Before disconnecting the spark plug wires, be sure to trace their orientation from the individual cylinders back to the distributor cap.

    • The cylinders are ordered from left to right when viewing the engine from the front of the car, with cylinder #1 being closest to the passenger side of the vehicle.

    • Mark the order of the spark plug wires on the new distributor cap with a silver sharpie marker -- it will make reinstallation much easier.

    翻译

  2. 1998-2002 Honda Accord Distributor Cap Replacement: 步骤 2 中的图像 1，1

    • Disconnect the four spark plug wires from the distributor cap by pulling their connectors straight away from the sockets on the distributor cap.

    • It may be helpful to slightly twist the wires as you pull them.

    翻译

  4. 1998-2002 Honda Accord Distributor Cap Replacement: 步骤 3 中的图像 1，2 1998-2002 Honda Accord Distributor Cap Replacement: 步骤 3 中的图像 2，2

    • Use a 1/4" drive, 8 mm deep socket to remove the three hex bolts securing the distributor cap to the engine.

    • The position of the third bolt is not visible in the second picture.

    翻译

  5. 1998-2002 Honda Accord Distributor Cap Replacement: 步骤 4 中的图像 1，1

    • Pull the distributor cap away from the engine and set it aside.

    翻译

  6. 1998-2002 Honda Accord Distributor Cap Replacement: 步骤 5 中的图像 1，2 1998-2002 Honda Accord Distributor Cap Replacement: 步骤 5 中的图像 2，2

    • Use a dental pick or a small screwdriver to gently remove the D-shaped o-ring around the distributor cap flange.

    • Install a new o-ring in the seal recess, making sure that it is sitting flush against the flange.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

13等其他人完成本指南。

4条评论

I need to do this procedure. Have never done this in years. Next time I will change my wires, plugs and now my distributor cap.

Thurman - 回复

Where can I find the part number?

lawendellr - 回复

what about 6 cylinder

ssingam75 - 回复

excellent, thanks for you aportation.

julio cesar - 回复

添加评论

浏览统计数据:

过去 24 小时： 7

过去 7 天： 26

过去 30 天： 113

总计 68,279