跳转到主内容
  1. Firstly Disconnect  battery Always take the negative terminal off first.
    • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

  2. Unlatch the 2 clasps. Loosen screw on metal band.
    • Unlatch the 2 clasps.

    • Loosen screw on metal band.

  3. Disconnect electronic sensor. Press on the 2 latches, pulling the cable away from sensor.
    • Disconnect electronic sensor.

    • Press on the 2 latches, pulling the cable away from sensor.

  4. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  5. Disconnect hose from MAFS. Remove MAFS.
    • Disconnect hose from MAFS.

    • Remove MAFS.

  6. Steps 4-6 are for cleaning only.
    • Steps 4-6 are for cleaning only.

    • Spray MAFS cleaner along direction of travel, shown by arrow.

  7. Clean electronic coupling with electronics cleaner. Clean electronic coupling with electronics cleaner.
    • Clean electronic coupling with electronics cleaner.

  8. Inject conducting lubricant into  MAFS electronic coupling. Inject conducting lubricant into  MAFS electronic coupling.
    • Inject conducting lubricant into MAFS electronic coupling.

  9. Re attach MAFS to air filter housing and intake hose. Tighten screw on metal band. Latch clasps on either side of MAFS.
    • Re attach MAFS to air filter housing and intake hose.

    • Tighten screw on metal band.

    • Latch clasps on either side of MAFS.

  10. Re attach electronic cable to MAFS.
    • Re attach electronic cable to MAFS.

结论

To reassemble your device, follow these instructions in reverse order.

Isaac Nitschke

于2010年10月11日注册

61 信誉积分

创作了5篇指南

团队

Cal Poly, Team 3-28, Regan Fall 2010 Cal Poly, Team 3-28, Regan Fall 2010 的会员

CPSU-REGAN-F10S3G28

4 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 9

过去的30天: 32

总计 8,147