简介
你所需要的
-
-
将蓝色手柄拉向铰链以解锁反向钳的手臂。
-
将反向钳手臂滑过 iPhone 的左边缘或右边缘。
-
将吸盘放在靠近 iPhone 底部边缘的位置——一个在正面，一个在背面。
-
向下推吸盘以将吸力施加到所需区域。
-
-
-
-
捏住露在外面的透明塑料标签并向右拉，这样电池就会完整地从机身上脱离。
-
如果你无法顺利地取下电池，可以借助iOpener工具，或者使用吹风机加热iPhone背部对应电池的区域来软化粘合剂。
-
拉胶的塑料标签强度不高，有可能会被扯断。如果你在取下电池前弄断了标签，可以按照以下步骤补救。
-
-
-
逐步去除连接后壳并保护Lighting接口和扬声器的螺丝：
-
一颗 2.5 mm 的十字螺丝
-
两颗 3.3 mm 的十字螺丝
-
一颗 2.9 mm 的十字螺丝
-
两颗 1.5 mm 的十字螺丝
-
一颗 2.8 mm 的十字螺丝
-
请倒序重组你的设备。
请倒序重组你的设备。
512等其他人完成本指南。
67条评论
Just a quick note that if you're doing this teardown because your iPhone 5 isn't charging unless you apply some force to the Lightning cable, the problem may simply be some lint or other crud in the Lightning port. Blow some compressed air in there before you disassemble your iPhone and see if it solves the problem - it did for me.
Adam Engst - 回复
ifixed my i5 by cleaning the port too (was just about to buy the kit!). I found a paper clip done the job perfectly.
Cheers, Adam Engst.
Also found dirt was the only fault with a number of 5's.
Gary -
Well I bought the replacement first and then realized about the dirt. I removed the dirt and it is now working again. I guess after 2 years the thing accumulates quite a bit of dust.
esleep -
THANK YOU for your comment, Adam, and the others that took the time to confirm it worked for them. Thankfully I read it before attempting this repair on my iPhone 5S. It took only 10 seconds with a very skinny (<1 mm) screwdriver, scraping the deep edge of the port, and I pulled out a wad of pocket lint that was about the size of a pea when uncompressed. A paperclip would have done the job. Charger works perfectly now.
Erin S -
