☐

The image is too blurry to recognize any text content.

eMac

[ ]

The following tools are recommended for the take apart procedures.

• 2.5 mm hex (for rear housing)

• phillips #2 screwdriver

• jeweler's screwdriver set

• needlenose pliers

• ESD wriststrap and mat

• CRT discharge tool

Note: Do not use a power driver on the rear housing screws.

[2]

CRT Neck/Display/Analog Assembly Handling Information

Handling

Important: It is imperative that proper handling and packaging guidelines be followed when working with the display/analog assembly.

Do NOT lift, handle, bump, or manipulate the CRT neck/neck board (see red arrows below) on the Display/Analog assembly. Modules damaged by mishandling are NOT covered by Apple Warranty. Apple Authorized Service Providers can be liable for broken CRT necks due to improper handling.

Caution: The metal chassis has sharp edges, you may want to wear gloves when handling the assembly. Lift the assembly from the metal chassis; never lift the assembly from the neck.

福

Packing a Defective Display/Analog Assembly

The packing procedure is included with the replacement display/analog assembly. Incorrect packaging can result in damaged eMac displays. Please read and follow the directions enclosed in the shipping box of the new display prior to packaging the defective assembly. AASPs can be liable for broken CRT necks due to improper packing and handling.

User Access Door

Tools

This procedure requires the following tools:

• Phillips #2 screwdriver

Part Location

0

Preliminary Steps

Before you begin, do the following:

• Place the computer face down on an ESD mat.

Procedure

1. Remove the screw on the user access door

2. Gently remove the access door.

0