修复你的物品 社区 商店

型号A1367，闪存容量：8、16、32及64GB

914 个问题 查看全部

更多选项

Questions about iPod Touch 4 disassembly

Hi! I have fixed iPhone 4 and am very comfortable working with them, but recently I have tried fixing damaged iPod touches, specifically ones with damaged screens.

These forth gen iPods have very annoying soldered flex cables for the volume and power.

Does anyone have any tips for me to avoid ripping the speaker out when removing the shield with a lot of screws? And avoid ripping that flex cable when installing the digitizer ribbon?

I have used patience and care, but they always seem to rip and become even more headaches for me!

Any tips would be appreciated thanks ;)

已回答！ 显示答案 我也有这个问题

这是一个好问题吗？

是 否
得分 -1
添加一条评论

2个答案

筛选条件:
最有帮助的 最新 最老的
已选择的解决方案

更多选项

Hi

I Have done this a few times at it is a huge pain. I have broken a flex cable before. TO do this I usually put the casing of the ipod in a small vise and gently lift the circuit board as far as it will go without damaging the cable, use a small piece of plastic, usually the rear end of a small ipod opening tool to hold in this position. Then I use small tweezers to line up the cable. That is just how I do it their are probably better ways

这个答案有帮助吗？

是 否
得分 0

1条评论:

I put my fingers on the speaker side to hold it down.. Gives enough room leverage to lift the top side/right corner and do the fitting.

由完成的

添加一条评论

更多选项

To keep the volume cable from ripping try holding down the motherboard BEFORE you pry the metal plate off.

To keep the speaker from ripping off try heating the plate in that area before prying the plate from speaker. I metal spudger is the best tool for this.

If your not comfortable with either save your self the trouble and get a pro to do it for you.

这个答案有帮助吗？

是 否
得分 0
添加一条评论

添加你的答案

D D 将永远感激不已
浏览统计数据:

过去 24 小时： 0

过去 7 天： 0

过去 30 天： 0

总计 451