声誉积分: 441
4
3
I have accidentally removed the pod on the pcb board of the iPod. It's the one in the middle. Does someone have a diagram of what each of those pods do and a possible fix? Thank you! Ps- I still have the removed pod. Any ideas?
*bump*
声誉积分: 781.3千
1.1千
892
2.3千
chris, if you are talking about the solder pads, take a look at the attached image. It is from a 3rd gen but should still be the same. If your pad came of the board, it can be tricky to repair it again. Take a look at this video. Decent tutorial and it might help you to see what you are up against. If you have difficulty soldering etc, then you could try something like this epoxy.
这个答案有帮助吗？
While the information provided is good the solder points are different on the 3rd gen.
声誉积分: 13
2
Posted about this outside.
http://www.techjamaica.com/forums/showth...
That is for the A1367 4th Gen iPod Touch. Hope it helps.
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 1
总计 2,655
1条评论
Chris, I assume you are talking about the solder pads?
由 oldturkey03 完成的