Replaced Screen, phone powers on and responds to touch, no display
I recently decided to try and fix my iphone 8 screen as the old one had many static type lines running through it. I went through the exact installation steps and took the necessary steps. However, once I reassembled the device the screen remained black. The screen does seem to respond to touch, as I unlocked it from blindly typing in my pin and I am able to use siri to carry out basic commands. I did try to put the original screen back on and the phone showed the apple logo for a few seconds when I switched back to it, but then once again stopped displaying after booting into the spring board. I honestly do not know where to turn at this point and any information or advice would be much appreciated.