更多选项

NO IMEI, NO Signal, NO Activation - PP_1V0_SMPS5 Low resistance

I have an iPhone 7 NO IMEI, NO Signal, NO Activation.

I have REMOVED BBPMU_RF chip and measured values in diode mode. I found out that Pad #87 which is PP_1V0_SMPS5 line. (See attached Image) The measured value is 0.053. The normal values according to ZXW Tool is 0.248

and Pad #99 which is PP_SWS_S5 the measured value is 0.043. The normal values according to ZXW Tool is 0.245

I have also checked

WHAT I DONE:

I have REPLACED BBPMU_RF chip with a new one but problem still exist.

I have checked visually all capacitors around BBPMU_RF chip (No damage all looks good)

I have measured all voltages around BBPMU_RF. All OK.

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 0

添加一条评论

发帖于: 2020年5月27日

更多选项

On the Qualcomm boards this problem starts at the BBPMU from flexation we presume as it is closer to the flex line than the Intel boards which don’t suffer from this problem.

On the Qualcomm boards when the BBPMU IC fails it usually sends a higher voltage to the BBCPU which cannot handle it and develops a short.

I wouldn’t spend too much more time on this phone unless it has had the audio IC repaired which I would than remove and re-ball the BBCPU.

Don’t rely on the ZXW readings always compare to a known good board.

这个答案有帮助吗？

是否

得分 1

1条评论:

I can not tell if the IC was repaired or not. I guess it has not been touched since There is no flux arund it or can not see any jumper....

由 Peter Hupuczi 完成的 2020年5月28日

添加一条评论

iPhone 7

NO IMEI, NO Signal, NO Activation - PP_1V0_SMPS5 Low resistance

Update (05/28/2020)

1个答案

添加你的答案