跳转到主内容

Fourth generation of iPad, released November 2, 2012, available in 16, 32, or 64 GB models. Model Number A1458

217 个问题 查看全部

Glass shards in Logic board connector?

I have recently removed a badly-shattered iPad 4 screen, and installed a replacement.

About 5/6ths of the way down the screen, there is an (invisible) horizontal band, running the entire width of the screen, that is completely unresponsive to touch. I have tried two different screens, with the same result.

On close inspection of the sockets where the digitiser ribbon connects with the logic board, I noticed one was slightly cracked and raised, suggesting a stray piece of glass (or other debris) has managed to get stuck in there. There is also evidence of a deformation of the ribbon end, resulting from when I pushed the ribbon into its socket.

Does anyone have any experience of this and could suggest the best way of cleaning out the socket? Should I use compressed air, or isopropyl alcohol, or is there a better method?

All suggestions gratefully received.

回答此问题 我也有这个问题

这是一个好问题吗?

得分 1
添加一条评论

1个答案

Try using a little compressed air. By the sounds of it that shard could be lodged within the connector at this point and may need to be replaced. If that’s the case, you should be able to send it to Jessa of iPad Rehab, and they’ll be able to replace the connector. Good luck!

这个答案有帮助吗?

得分 0
添加一条评论

添加你的答案

Christopher Davies 将永远感激不已
浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 36