High Fan RPM and No Airport Hardware Found

It is quite obvious: The cable connects camera and airport card to the logic board. I'm not shure but i think there is even a themp. senor for the LCD - if that can't be read the fans will ramp up.

Judging from your pictures you might still have a chance to connect the cable and secure it afterwards with thermal resistant tape such as kapton.

这个答案有帮助吗？

是否

得分 2

2条评论:

Hi remacberlin

I tried to conect the connector and fits well but i think that any pin is damaged.

One question, above the connector have a padded sticker, this is necessary to works the connector?

由 Juan Ramos Martinez 完成的 2011年7月27日

You can leave the pad off, no problem. Try (very carefully) to correct the bent pin with a needle or similar.

由 remacberlin 完成的 2011年7月27日

添加一条评论

Hi remacberlin

I tried to conect the connector and fits well but i think that any pin is damaged.

One question, above the connector have a padded sticker, this is necessary to works the connector? — Juan Ramos Martinez
You can leave the pad off, no problem. Try (very carefully) to correct the bent pin with a needle or similar. — remacberlin