Battery Solder Pad scraped off iPod Touch 5th Gen

Question

第五代 iPod Touch 的

4英寸屏幕；多种颜色可选；共发布三款型号；闪存容量：16、32及64GB

331 个问题查看全部

Blake @blakeje

声誉积分: 13

1

发帖于: 2019年8月7日

更多选项

Battery Solder Pad scraped off iPod Touch 5th Gen

So… I messed up badly. I have done a few of these for friends over the years but this time it went south. While de-soldering the old battery I accidentally pulled off the first solder pad on the battery connector. So my question is how to I go about fixing this. Is there somewhere else I can run a small wire to or is it worth trying to cut into the old trace. (never done that before) Also if somebody has a wiring diagram as I’m not sure which pad I pulled.

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 1

1条评论

Did you get a solution for this prblem ? I have the left and the right pad broken .

由 reijk 完成的 2020年11月15日

添加一条评论

2个答案

已选择的解决方案

Minho @refectio

声誉积分: 221.4千

15

289

807

发帖于: 2019年8月7日

更多选项

There is no boardview for this device. However, the battery connector is pretty simple. The middle pad is the gas gauge line and the other two are VCC_MAIN (+) and Ground. Just probe the one on the right to see if it is connected to ground or not.

As for the missing pad, clean up the worksite so we can see if a trace connecting to it is visible. If it is, just scratch away until you can see the copper trace and then solder a thin wire in place. If you can’t see a trace, you will have to probe around to find something connected. Once again, if it is ground, that will be easy. If it is VCC_MAIN, then probe some surrounding caps.

这个答案有帮助吗？

是否

得分 4

1条评论:

HI,

You did not show or tell where you found a trace for the VCC-Main. Do I have to scrape all the logic board ?

I could not make out if the trace

is well or not connected to ground. How do you probe to see if it is connected toground or not ?

I found a trace above the solder pads , but when connected to a set of AA batteries,4.5V,( for safe trying ) they became very hot so no good connection.

I hope you can help me.

由 reijk 完成的 2020年11月14日

添加一条评论

Did you get a solution for this prblem ? I have the left and the right pad broken . — reijk
HI,

You did not show or tell where you found a trace for the VCC-Main. Do I have to scrape all the logic board ?

I could not make out if the trace

is well or not connected to ground. How do you probe to see if it is connected toground or not ?

I found a trace above the solder pads , but when connected to a set of AA batteries,4.5V,( for safe trying ) they became very hot so no good connection.

I hope you can help me. — reijk