声誉积分: 1
1
My hotpoint dishwasher (HDA2000G02CC) isn’t cycling properly, even at the very start of a wash cycle it appears to be running without water. If I turn the dial one click it starts to fill - and when filled it’s hot and has the right amount of water. The motor and fill valve were replaced and then it started. I replaced the timer and it didn’t fix it. I’m not sure what to try next.
声誉积分: 685.3千
3.4千
1.1千
2.6千
I know this may sound simplistic and I may not totally understand the problem, but would pulling the knob and replacing it back one click counterclockwise put it into the correct position?
这个答案有帮助吗？
@mayer just tried it, there wasn’t really anywhere to turn the know to, it only fits in one direction. I did just notice that the detergent cup lid seems to have disconnected, would that cause an issue?
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 5
总计 380
2条评论
What is the procedure for starting the wash cycle?
由 mayer 完成的
@mayer just simply latching the door and turning the dial clockwise until it turns on. I always do the full wash (start with prewash and let it run through) and never had a problem until the motor was replaced.
由 Behr 完成的