跳转到主内容

2016年9月16日发售。型号有A1661,A1784和A1785,支持GSM 和 CDMA 格式,存储容量有32GB、128GB以及256GB,颜色有玫瑰金、金色、银色、黑色、新的亮黑和红色。

1361 个问题 查看全部

Replaced Camera, Home button not working

My 7 plus rear camera stopped working. Put a new camera in and works like a dream. Rear camera and flash back on. Now my home button is not working. Any suggestions? Which cross over cables are related to home button function?

已回答! 显示答案 我也有这个问题

这是一个好问题吗?

得分 0
添加一条评论

2个答案

已选择的解决方案

The iPhone 7/8 series have a very inconvenient bend on the Home Button flex. It’s really easy to tear the flex, either near the logic board connector or at the 90 degree bend before it sneaks underneath the LCD heat shield. You have to be careful when you lift the screen off the first time but also anytime the flexes are connected and you have the device open.

The other area that is easily damaged is the connector on the Home Button itself and the opposite connector on the short flex that runs underneath the heat shield.

 The long and short of it is that there are multiple failure points. You will need to carefully inspect the Home Button and flex to see if there is any damage. Magnification here will help.  Look for tears to the flex or any physical signs of damage. You should also check the connector to insure none of the pins are damage or that there isn’t any debris.

 Unfortunately, there is no real DIY way to fix a Home Button, only Apple can replace it.

EDIT

The flex with the smaller connector is the Home Button Flex. The highlighted area is where they tend to tear but sometimes also near the connectors on the flex.

Block Image

这个答案有帮助吗?

得分 4

1条评论:

Are the flexes you speak of the 2 plugs next to where the battery connects? And can these ribbon wires be replaced?

完成的

添加一条评论

There are a few reasons the home button might not be working. If all you replaced was the back camera then you should not have needed to remove the home button from the screen assembly. All you would have needed to remove was the home button extender flex cable. This is the flex cable that attaches to logic board. As long as you didn’t remove the home button from the screen or remove the bracket, you’re home button should still be fine.

Does the phone still respond if you “press” the home button? If so, then you could have simply miss aligned the connector or you damaged the extender flex cable. Either way, I’m sure your home button itself is fine. Might just need to replace the screen or realign the flex cable.

If you do need to replace the screen, use extreme caution when removing the home button so you don’t rip the cable. If you break the actual button, you’re screwed.

这个答案有帮助吗?

得分 0

2条评论:

You are correct I did not remove home button. And no the phone is not "clicking" for the home button

Can this flex cable be purchased separate?

完成的

As far as I know you can not just purchase the home button extender cable as I'm almost positive it's part of the screen assembly.

完成的

添加一条评论

添加你的答案

Marc Prager 将永远感激不已
浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 105