跳转到主内容

苹果官方于2015年9月25日正式发售iPhone6S A1688/A1633机型。 此机型的修理方式与先前几代差不多, 需要螺丝起子及撬棍工具。 同时也适用GSM or CDMA/16, 64 or 123 GB/ 银色, 金色, 深空灰色, 玫瑰金色等机型。

1932 个问题 查看全部

Backlight turns off/on cold hot

Hi guys I have an iPhone 6s in repair from a fall in the water, I made ultrasonic cleaning and has broken down but the backlight sometimes disappears and if you spot a flashlight you see, the touch is working without backlighting. I tried another screen the same thing, I noticed that it warms up near the processor! Can the filters be?


Update (10/17/2018)

Block Image

Block Image

Block Image

已回答! View the answer 我也有这个问题

这是一个好问题吗?

按维修分数 0
添加一条评论

iPhone 电池维修工具包

只要 $29.99

Buy Now

iPhone 电池维修工具包

只要 $29.99

Buy Now

1个答案

已选择的解决方案

There are probably shorted filters, capacitors used to power the left / right hand side of the screen’s backlight circuits.

It would be obvious which components are the culprit if you take note of any corroded components on the board before ultrasonic cleaning. You may be still able to notice under microscope but it’s going to be harder as the evidence is mostly gone after ultrasonic cleaning, which is personally why I prefer to replace / remove corrosion from suspect components before ultrasonic cleaning).

If I’m correct these are under the metal shield that covers the processor and backlight driver circuit. You can inspect most of the components behind the logic board as you can peel the sticker on both the metal shields.

You’ll need to measure some capacitors, filters, coil for backlight circuit with a digital multimeter and see if they are shorted to ground (both sides of components show no resistance to ground)

I’m not exactly sure what components should be measured but I’ll page @refectio for advice on how to proceed with diagnosing no backlight.

这个答案有帮助吗?

按维修分数 2

评论:

With a water damaged phone, the problem is probably more at the circuit level (IC, Diodes, Coils, Capacitors) than at the filter level. I would start by probing the LCD connector against a known-good device or the values found in ZXW/WuXinJi. Then work your way from there.

If the lines are shorted, then check the filters and caps near the connector. Then move towards the circuit (you'll have to remove the CPU shield). Usually, the glass diode is floating around because the excess heat lifted a pad. Probe the circuit but sometimes the easiest fix is to wipe the circuit clean and rebuild from scratch with new parts (commonly referred to as a windshield wiper repair ;>).

添加一条评论

添加你的答案

Andrea 将永远感激不已
浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 33