Advice on a component I knocked off

Question

iPhone 6s

苹果官方于2015年9月25日正式发售iPhone6S A1688/A1633机型。此机型的修理方式与先前几代差不多, 需要螺丝起子及撬棍工具。同时也适用GSM or CDMA/16, 64 or 123 GB/ 银色, 金色, 深空灰色, 玫瑰金色等机型。

2688 个问题查看全部

Jacob @jacob25424

声誉积分: 1

1

发帖于: 2018年8月5日

更多选项

Advice on a component I knocked off

Hey i was hoping to get some advice, I accidentally knocked off the C0552 capacitor on an iPhone 6s when i tried unplugging a connector.. it was so small!

I wasnt originally attempting a board repair until this fell off so im worried that it might be something critical.

From what i see in the schematic its part of the “NORTH DC CURRENT BLOCKING CAPS” Screenshot: https://imgur.com/a/XIjDRMH

Thanks I appreciate all the help i can get, I’m interested to seeing what its function on the board is too :)

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 0

添加一条评论

3个答案

已选择的解决方案

Minho @refectio

声誉积分: 221.4千

15

289

806

发帖于: 2018年8月6日

更多选项

This capacitor is pretty easy to source; you can find them at DigiKey or Mouser. Soldering them is another story however as they are quite tiny.

That said, I don’t think it needs to be replaced. These four caps are there to filter out any noise on the the NORTH_AC_GND_SCREW line which is where the antenna interconnect resides. These caps are designed in to optimize performance when manufacturing tens of millions of devices. I would try to simply rebuild the device as is and see how it performs, If you don’t see a difference, then don’t bother with it.

这个答案有帮助吗？

是否

得分 2

添加一条评论

Stephen @techstuff 声誉积分: 397 3 · Answer 1 · 2018-08-05T19:59:55-07:00

Stephen @techstuff

声誉积分: 397

3

发帖于: 2018年8月5日

更多选项

Hey Jacob

You can replace the capacitor from a 3rd party vendor, and you will have to solder the new one back on. Im not sure who carries the capacitors for the Logic Board though. The easier route would probably be just to replace the Logic Board entirely. You can find a Logic Board for your iPhone 6s inexpensively to install so you don’t have to mess with soldering components or matching individual codes and specifications.

You can try Amazon or Newegg for the Logic Board, those two would have reasonable prices. For the capacitor I’m not sure who would sell it.

Good Luck!

这个答案有帮助吗？

是否

得分 1

3条评论:

I suppose i could find a water damaged iphone dirt cheap and see if it has a cap thats in good condition and pass it onto someone who can smd solder, I'm curious what the function of this cap is, do you know?

由 Jacob 完成的 2018年8月5日

This capacitor is for a section of antenna's that are routed through the chassis on the northern bottom side. So it would be very difficult to solder it back on.

由 Stephen 完成的 2018年8月5日

I would strongly suggest to replace the Logic Board itself, that would save you a ton of time and labor

由 Stephen 完成的 2018年8月5日

添加一条评论

Sam @sam82054 声誉积分: 187 Midwest Phone Lab 4 1 · Answer 2 · 2018-08-08T12:59:07-07:00

Sam @sam82054

声誉积分: 187

Midwest Phone Lab

4

1

发帖于: 2018年8月8日

更多选项

Here’s board view for both sides of that cap.

Thankfully it’s not located in a terribly crowded spot on the board, but still very, very tiny. Unless you have much experience with micro soldering I’d say either get it repaired by a professional board level repair shop, or replace the logic board. the phone will likely function just fine without this capacitor (as @techstuff mentioned) but it is probably safer for the phone to replace it.

这个答案有帮助吗？

是否

得分 1

1条评论:

Exactly! better to be on the safer side rather than a dangerous side. Replacement would definitely prevent any danger such as shorts, fire, or iOS corruption.

由 Stephen 完成的 2018年8月8日

添加一条评论

iPhone 6s

Advice on a component I knocked off

3个答案

添加你的答案