iPhone 6 Plus sometimes auto restart?

Question

iPhone 6 Plus

2014年9月19日发布的iphone 6 Plus有着比iphone 6大的5.5英寸屏幕。

1525 个问题查看全部

Azim WHITE @azimwhite

声誉积分: 263

5

13

发帖于: 2018年7月26日

更多选项

iPhone 6 Plus sometimes auto restart?

Hi I got an IPhone 6 plus water damaged and came with short on VCC_Main Cap near the Audio IC. After removing the shorted Cap the phone works normally, but then after a few days the phone came in with with a new issue :

.

1. Always restart itself

2. Battery percentage is not normal, like sometimes 80% and directly decrease to 5% and suddenly it turns off.

.

So I take a further step by changing the Charging IC (U1700). After changing the Charging IC the IPhone works well, but just for a few hours the issue CAME BACK (but the percentage issue is solved). Diode Mode on Vcc_Main looks normal to me around 350.

.

So my question is, do I need to change the Tigris Chip ? Is it possible that the issue came from the CPU ? What should I do next

已回答！ 显示答案我也有这个问题

这是一个好问题吗？

是否

得分 0

添加一条评论

2个答案

已选择的解决方案

Minho @refectio

声誉积分: 221.4千

Refectio - Mail-in Micro-Soldering Repairs & Data Recovery

15

289

806

发帖于: 2018年7月27日

更多选项

It seems to me like you are just guessing at what the problem is. That can work, sometimes, as there are typical failure points but the issue is that every time you apply heat to replace an IC, you are risking collateral damage.

A restart issue can be caused by a lot of things and Tigris is really only used for charging, which you repaired. So changing Tigris for no reason is not a good use of your time.

Have you properly decontaminated the logic board? If you have, then start probing the PMIC / BBPMU outputs and compare to a known-good device. Then check the I2C and RESET lines to see if anything weird is going on.

这个答案有帮助吗？

是否

得分 2

3条评论:

How can I know which Cap is the output for the PMIC/BBPMU ?

由 Azim WHITE 完成的 2018年7月27日

Look at the schematic and identify all of the outputs (i.e. PP_CPU, PP_GPU etc.) then look for the best testing points (i.e. C1290, C1203). BBPMU is the power unit for the baseband circuit and is different than the PMIC.

由 Minho 完成的 2018年7月27日

Okay ill try to check it back tomorow and also ill update about the result soon. Thnx your suggestion was very helpful

由 Azim WHITE 完成的 2018年7月27日

添加一条评论

Look at the schematic and identify all of the outputs (i.e. PP_CPU, PP_GPU etc.) then look for the best testing points (i.e. C1290, C1203). BBPMU is the power unit for the baseband circuit and is different than the PMIC. — Minho
Okay ill try to check it back tomorow and also ill update about the result soon. Thnx your suggestion was very helpful — Azim WHITE