声誉积分: 13
2
1
See photo:
This is a connector for an Ipad Pro charging port. I am replacing this however, when I took the old one off half of this pad came off..
Can I solder to this pad with majority of it gone or do I have to run a jumper? I am just learning so please have some mercy. Thank you!
声誉积分: 782.1千
1.1千
893
2.3千
@smitty1510 yes you can but you better be good at it. No room for fudging and you only have one chance.
这个答案有帮助吗？
@oldturkey03 I need to run a jumper... No schematic or BV available for this model. Not on ZXW either... Any Ideas? How can I find out where to run the jumper?
@smitty1510 there is no way unless you have the schematic.
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 3
总计 108
