I recently did quite a routine repair on an iPhone 6 screen. However, after the screen was placed in and the phone powered on (yes with original home button) there was no touch ID. i then tested the sensor with the old screen to see if it was an issue with the ribbon cable behind the screen and the same error message popped up. there are no visible tears to the home button flex cable or damage to the logic board also.
声誉积分: 221.4千
15
289
807
It doesn't take much to damage the Home button. If you have access to a magnifying glass or jewelers loupe, look at the flex cable within the Home button again. All it takes is a tiny tear on the edge to seal its fate.
这个答案有帮助吗？
Yeah looked over it with a magnifying glass fairly sure the cable is intact
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 0
总计 56
