声誉积分: 25
3
I replaced the digitizer on an iPad Air 1. The iPad shows that it is charging and the tone is heard when plugged in, still it does not charge above 40%. I am using an official charger and cable that works on another iPad. This is not the first digitizer that I have replaced. I have reset and downloaded the most current iSO. I followed the ifixit instructions. I am at end on what to try next. Any help will be greatly appreciated.
声誉积分: 25
3
I was able to find the answer to the problem. I decided to totally disassemble the iPad. Upon doing so I found that a very small piece of digitizer glass was between the battery connections. It must have went in there when I place the isolator pick in. I reassembled the iPad and now it is charging.
这个答案有帮助吗？
Awesome...sometimes it takes sharp eyes to see these tiny issues!
声誉积分: 221.4千
15
289
806
There are a few possibilities here:
这个答案有帮助吗？
Minho, after replacing iPad Air battery and digitizer I am having a problem charging. I suspect it could be one of the 2 problems you listed. What would be the solution to these 2 problems?
@daltmann The problems I outlined require micro-soldering repairs and are not typically DIY repairs.
Minho, would replacing the logic board fix it?
@daltmann replacing the logic board is like replacing the device. The cost is pretty similar to buying a used device.
声誉积分: 1千
3
It charged fine before the replacement? Was the battery disconnected before the repair or did you leave it screwed in?
The digi would not cause the charging issue. First thing I would do is check for any damage to the battery or chargeport flex. It's easy to slip and nick these during the repair. If there is no signs of damage I would then try a new battery. If it charging at all then it's not likely the chargeport that's the issue.
这个答案有帮助吗？
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 6
总计 1,996
