跳转到主内容

发布于 2012 年 6 月, 型号 A1278. Intel 处理器,支持 Turbo Boost, 最多 512 MB DDR5 显存

1649 个问题 查看全部

820-3115 - Cleaned up after Liquid Damage but corroded pads remained

Hi,

I spilled my well deserved after-work beer while cleaning with the tube of my vacuum (d'oh) over my Macbbook and it turned off immediately.

Much sad.

I disassambled it immediately und pulled off the battery.

I cleaned it with a soft ESD-Safe brush and lots and lots of Isopropyl.

The result is not very promising - or is it?

May I turn it on without damaging it more? Should I sell it as it is?

I have a hobbyists hot air station (Uvistar 858D) and as well a soldering iron (ZD-937), but I am not good at SMD-Soldering. Anything I could & should try with this equipment?

Why are the pads turning copper? Did I brush too hard and ripped them off or is it a chemical reaction?

I did not dare to turn it on after cleaning. What would you do?

I have seen ultrasonic cleaners on ebay for 70€ - 80 Watts and 40kHz - cheaper than going to a repair service. Good idea or too late for my board?

Greetings!

Jonas

Block Image

已回答! 显示答案 我也有这个问题

这是一个好问题吗?

得分 0
添加一条评论

1个回答

已选择的解决方案

@jonase either really strong beer or a bit to much scrubbing. Looks like you rubbed the solder of but that is not always detrimental. Either your image is a bit fuzzy or the board is still not well cleaned. At this point I'd go and have it cleaned by someone who uses an ultrasonic cleaner. If you have not turned it on since "the accident" you stand good chance to recover this board, I would not yet give up.

这个答案有帮助吗?

得分 1

评论:

Good - I'll go with one of those chinese ultrasonic from ebay. My wife likes that she can clean her stuff as well and I also have defective /old PCBs from time to time. So 70€ are well spent if it is working

完成的

添加一条评论

添加你的答案

jonase 将永远感激不已
浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 82