声誉积分: 1.6千
12
5
3
Customer brought in an iPad Pro 12.9" with a cracked screen. I replace the screen and soldered the new one on properly 100%. Customer has issues with the dead spot on the screen. So I ordered a brand-new digitizer assembly and install that one. Exact same issue as the first one. Anybody have any suggestions? No apparent damage to the control board and soldering is good. Thanks!
声誉积分: 1
1
then the controller board is bad, simple
sounds to me like proccess of elimination its the controller board, too much heat, etc can damage a controller board, hope you find a solution.
这个答案有帮助吗？
声誉积分: 61
3
lcd is not ok failure
这个答案有帮助吗？
LCD is perfectly fine on both. Ordered from 2 separate manufacturers, dead spot in same exact area.
过去 24 小时： 0
过去 7 天： 1
过去 30 天： 2
总计 475
Same supplier? Seconds?
由 mayer 完成的
Different Supplier. LCD is good on both.
由 GadgetERService 完成的