跳转到主内容

Model A1138 / 1440x960 screen resolution

85 个问题 查看全部

Why can't I get the last two screws to go in?

The last two screws on the bottom near the hinge won't go all the way in? All the others are perfect. Any ideas?

已回答! 显示答案 我也有这个问题

这是一个好问题吗?

得分 -1
添加一条评论

2个答案

已选择的解决方案

Go back over the guide to see if you installed a couple of shorter screws into longer holes.

这个答案有帮助吗?

得分 2

6条评论:

Seems likely +

完成的

No, they are identical, the longest of the lot. They only miss by a little, like they have bottomed out. Tight, but not all the way in. I tried getting the blue Locktite off the screws to see if that would help, but no.

完成的

Please check the guide you used and the length of each screw (they are all listed). Use a millimeter gauge if you have one. Trust me, You have used shorter screws than required somewhere during your reassembly.

完成的

From the guide:

"Four 16 mm Phillips along the hinge.

Two 12 mm Phillips screws on the Aluminum bracket at the top of the memory compartment."

All the rest are 3 or 5 mm. If I had them swapped, I would have had to put a 16mm in the 12mm hole in the battery compartment.

完成的

What guide were you doing?

完成的

显示更多的1条评论

添加一条评论

The reciever

holes on the top case may be bent, blocked or stripped.

These two screws go to hold the back of the top case check the clearance and those tangs.

If this answer was helpful please remember to mark it accepted.

Good Luck,

N

这个答案有帮助吗?

得分 0

1条评论:

Top case, where the keyboard is? I won't be able to get to it until later, but I will pull that off and check. I replaced the DC & Sound Card because the DC in port pulled part of the power cord off, and was unusable, now the battery won"t charge. Getting power at some of the pins in the battery bay,

完成的

添加一条评论

添加你的答案

michaellarson 将永远感激不已
浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 822