跳转到主内容

各种形状、大小和颜色的安卓手机的维修指南和拆卸信息。获取DIY修理手机所需的一切。

33190 个问题 查看全部
问题已关闭

Is this Moto X saveable?

After about 3 months of ownership, the digitiser on my Moto X (XT1058) began to fail. At first it was just a bar on the screen that was unresponsive but then the digitizer failed completely. Upon sending it for repair, my service provider said that the phone had water damage and was unrepairable and not under warranty.

When I disassembled the phone, I did find some corrosion in one spot on the phone. My question is whether this phone is a write-off or is there a hope of repairing it. Full pics of the pcb can be found here

已回答! 显示答案 我也有这个问题

这是一个好问题吗?

得分 0
添加一条评论

1个答案

已选择的解决方案

Is that the digitizer connector near where the corrosion is shown in your picture? I have had luck with cleaning off the corrosion using a toothbrush and rubbing alcohol. It's worth a shot otherwise you'll have to try to find a replacement main board.

这个答案有帮助吗?

得分 0

4条评论:

Thanks I'll try that. I've never seen a main board for sale. Are they available?

完成的

You'd have to try to find one on eBay.

完成的

Weirdly, the corrosion was around connector for the rear-facing camera. It did clean up nicely with some 99% isopropyl alcohol but that made no difference to the digitizer. Am at a loss to work out how to diagnose the problem now. Phone still boots up fine but digitizer still dead. I'd happily buy a new digitizer/screen if there was some way of determining that that would solve the problem.

完成的

It is unusual for a digitizer to fail without any physical damage and the liquid damage to the board leads me to believe it is most likely a main board problem. On the other hand a digitizer is only $10 on eBay and might be worth a try first.

完成的

添加一条评论
浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 91