跳转到主内容

The Canon EOS 7D was Canon's first high end professional camera with an APS-C crop sensor.

44 个问题 查看全部

My flash won't pop up on my EOS 7d

My flash won't pop up on my EOS 7d, any suggestions on how to fix this?

回答此问题 我也有这个问题

这是一个好问题吗?

按维修分数 1

评论:

I have the opposite problem - the pop up won't close - since it was new but hate to part with it to have it looked at

添加一条评论

Macbook 电池维修套装

起价 $69.99

Buy Now

Macbook 电池维修套装

起价 $69.99

Buy Now

4个回答

最有帮助的答案

In the flash shoe on the top of the camera, there is a metal spring plate. Under the plate you will find a white cylandars that goes through the hot shoe (about as thick as a paper clip). When an external flash is pushed onto the shoe, this pin is pushed down and tells the camera there is an external flash in the flash shoe. This disconnects the internal flash. Spillage can cause this pin to stick down. Remove the battery, and then put a little Windex on a clean toothbrush and clean the pinhole. Blow lightly to evaporate. The pin should pop up, but it might take a couple of cleaning attempts.

Another cause could be that sticky liquid spillage has gotten on the pivots for the flash. Once again, cleaned with small amount of Windex on a q-tip may free the pivot. One of the pivots is a screw. Sometimes it is rusted, and needs to have the rust scraped off and then a light coating of grease applied.

这个答案有帮助吗?

按维修分数 3

评论:

Thanks for this advice. It was exactly what I needed! You rock

Good advice, worked the first time.

添加一条评论

Excellent solution! 10 sec and it solved!

Thank you!

这个答案有帮助吗?

按维修分数 0
添加一条评论

In almost all the canon EOS camera I’ve seen this problem . In almost all cases it is caused by bad care of the camera. A large amount of faults are caused by dirty cameras. Grease from fingers, small amounts os dust and dead skin building up until it failed. The solution above is correct. But care is the problem linked with cleanliness. Not only the specific area and fix above but also the seating area must be clean. This is to often ignored. As is each area on a camera where to surfaces meet such as the lense

这个答案有帮助吗?

按维修分数 0
添加一条评论

Hi i own a 7d the problem is very likeiy to be in the little pin under the spring on the hot shoe on the right hand side

i have used isopropyl alcohol and a tooth brush when it has worked i then use a little crc or wd 40 on the end of a tooth pick to keep the pin from getting stuck again

i hope this helps

Update (03/08/2019)

Hi again

if you are living in new zealand i can give you an address to send your cameras to for repairs its CW Services ltd

62 church street

timaru

7910

new zealand —-or www.camerarepairs.co.nz

Greg is one of the best techs in nz for canon repairs

I have used him a few times and his costs are very fair

这个答案有帮助吗?

按维修分数 0
添加一条评论

添加你的答案

Andy 将永远感激不已
浏览统计数据:

过去的24小时: 3

过去的7天: 29

过去的30天: 150

总计 5,875