跳转到主内容

型号 A1059 或 A1099 / 20, 40, 或 60 GB 硬盘 / 中央转盘为触控激活

226 个问题 查看全部
问题已关闭

Hard drive ribbon - replacing when connector is broken

How is the hard drive ribbon connector attached to the logic board on a 4th gen 20gb ipod?

When releasing the tape over the connector it broke on me.

Would it be possible to use an adhesive on the ribbon cable to secure it to the logic board? Or can I buy a new connector and how would I secure it to the logic board?

Thanks!

已回答! 显示答案 我也有这个问题

这是一个好问题吗?

得分 0
添加一条评论

1个答案

已选择的解决方案

David McAllister, I believe you are referring to the Zif connector. If it is the clasp that has broken off, you could try and secure the cable with Kapton tape or similar. Do not use any liquid adhesive. Sometimes the clasp can be replaced from an old board. It is difficult to even get the connector, and if you do get it, it will have to be soldered onto the board. This requires the proper tools and lots of experience. It might be easier and a bit cheaper to just replace the board. Hope this helps, good luck.

这个答案有帮助吗?

得分 1
添加一条评论
浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 718