声誉积分: 1
1
1
I need this: MacBook Unibody (A1278) MagSafe DC-In Board
But I have access to a used one of these: [关联产品丢失或禁用： IF161-037]
How similar are they? Can I replace the 820-2361-02 with a 820-2565-A?
声誉积分: 13
2
I know this is an old issue, but I had the same scenario just occur: I had an 820-2361-A (identical to the 820-2361-02) that I wanted to replace with an 820-2565-A.
I did find as well that one of the screw-holes did not line up, but the other did. I tightened that one as best as I could by hand, crossed my fingers and plugged it in. Sure enough it seems to be working fine!
这个答案有帮助吗？
声誉积分: 1
5
2
This 820-2565-A is compatible with A1278 mid 2010 late 2010 & early 2011.
Good luck
这个答案有帮助吗？
it worked electrically, but the screw holes did not match. Turns out I have a separate problem.
Best to get the correct part as the MagSafe connection is not reliable as it will shift!
Just another data point. My:
17" Unibody MacBookPro8,3 Early 2011, Model A1297
requires the DC-IN board: 820-2361-A
Amazon sent the 'Power Jack Board 820-2565-A' by mistake. The second hole is off by about 2mm, and thus not possible to secure with the second screw. Chip and layout looked identical (but no way to know). Under deadline pressure, I proceeded with the install. Fixed and booted. So far so good. At first was concerned about DC-IN board rotating, but the pull of the magnetic connector does not apply inward pressure to the board.
这个答案有帮助吗？
I had the same issue. I tightened the screw closest to the corner and then in the process of trying to tighten the screw that is off by 2mm I snapped the sheath that attaches to the back of the board. Without the sheath the screw actually has enough room to attach.
Problem accidentally solved!
过去 24 小时： 0
过去 7 天： 0
过去 30 天： 1
总计 3,203
1 