跳转到主内容

第四代iPhone。维修过程直观易懂,但前置玻璃和LCD面板无法分开,只能作为同一零件更换。GSM版本, 8, 16, or 32 GB 容量 / 型号 A1332 / 黑色或白色

2375 个问题 查看全部

iPhone 4 screen is very sensitive to presure after a replacement

I can't get an answer to this question from anywhere. But after I replace a screen and put it all back together I boot the device and everything is good. Only if i put a little presure on the screen it has this color warp effect for a few seconds. As if the LCD is being squeezed. A factory iPhone does not do this. Is it cheap parts or is there a better reason? How can I avoid this?

回答此问题 我也有这个问题

这是一个好问题吗?

得分 -1
添加一条评论

5个答案

A stupid question maybe, but did you remove the protective film on the back of the new display?

The most common cause of this issue is that the replacement glass is of poorer quality and a bit softer than the original, so it flexes when pressurized. This causes the back of the LED-display to get squeezed between the glass and the metal plate housing.

这个答案有帮助吗?

得分 0

1条评论:

That's what I was suspecting. I tried to be cheap and get the screens off eBay but for the most part they are garbage. Ill keep ordering from my good supplier. And I did remove the film!

完成的

添加一条评论

Who is your good supplier? I have the same problem.

这个答案有帮助吗?

得分 0

1条评论:

Who is your good supplier? I have the same problem.

完成的

添加一条评论

I have been having this issue also regardless of the supplier. I am thinking it has to do with adhesive thickness being to thin which allows the glass to rest directly on top of the LCD.

I don't know the specs but I am pretty sure there should be some clearance between th glass and LCD. Most likely measure in micro inches.

Thoughts?

这个答案有帮助吗?

得分 0
添加一条评论

You goons keep ripping off the foam between proximity and light sensor and blame others for your mistakes. Put a barrier between this two, so they won't interfere......problem solved.

这个答案有帮助吗?

得分 0
添加一条评论

Here is your problem right here .

Remove battery and removed all adesive holding the battery in place either on the frame and the battery itself.. Also make sure the battery has not been bent or dented when it was removed if so give it a little straighing up.. Now install battery and no more pressure marks..

The cause of this is when the back cover is replace and the battery it bent or adesives making the battery sit up further the back cover makes it press hard on the inside of the lcd

这个答案有帮助吗?

得分 0
添加一条评论

添加你的答案

Kris 将永远感激不已
浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 3,079