跳转到主内容
帮助

当前版本: iRobot ,

标题:

After fall digitizer broke and back cover edge is a little bent

文本:

iPad 2 has fell on the ground and the digitizer broke. Unfortunately the edge of the back cover that hit the ground is a little bent too.

Is there any way to avoid replacing the back cover?

If I try to install a new digitizer without replacing the back cover will I have an issue during the installation?

Thank you in advance!

设备:

-iPad 2 Wi-Fi
+iPad 2 Wi-Fi EMC 2415

状态:

open

已接受的回答:

70170

编辑: iRobot ,

标题:

After fall digitizer broke and back cover edge is a little bent

文本:

iPad 2 has fell on the ground and the digitizer broke. Unfortunately the edge of the back cover that hit the ground is a little bent too.

Is there any way to avoid replacing the back cover?

If I try to install a new digitizer without replacing the back cover will I have an issue during the installation?

Thank you in advance!

设备:

iPad 2 Wi-Fi

状态:

open

已接受的回答:

70170

编辑: Theo ,

标题:

After fall digitizer broke and back cover edge is a little bent

文本:

iPad 2 has fell on the ground and the digitizer broke. Unfortunately the edge of the back cover that hit the ground is a little bent too.

Is there any way to avoid replacing the back cover?

If I try to install a new digitizer without replacing the back cover will I have an issue during the installation?

Thank you in advance!

设备:

iPad 2 Wi-Fi

状态:

open

已接受的回答:

+70170

原帖由: Theo ,

标题:

After fall digitizer broke and back cover edge is a little bent

文本:

iPad 2 has fell on the ground and the digitizer broke. Unfortunately the edge of the back cover that hit the ground is a little bent too.

Is there any way to avoid replacing the back cover?

If I try to install a new digitizer without replacing the back cover will I have an issue during the installation?

Thank you in advance!

设备:

iPad 2 Wi-Fi

状态:

open