跳转到主内容
帮助

当前版本: Dan ,

文本:

[quote]'''I'''I found a probable cause and solution!''' ''Once I was sure there was no warrantee in affect'' The

The
over heating seems to come from the MagSafe connection shorting out due to corrosion build up. I used a hard plastic picker to remove as much of the corrosion as possible. Also

Also
, I took small pieces of tape and pressed them into the recessed area to remove small pieces of metal that had begun to collect to the magnet preventing a tight connection of the electrical points. When

When
I was no longer able to get good clean points, I found just the MagSafe connector and cord on Amazon for about 10% of the original price! I

I
used buttbut joint crimp connectors and shrink tubes to assemble everything! Now I keep a small piece of gaffers tape over the recessed area to keep metal bits from collecting to the magnet[/quote]magnet
[quote]'''I'''I found a probable cause and solution!''' ''Once I was sure there was no warrantee in affect'' The

The
over heating seems to come from the MagSafe connection shorting out due to corrosion build up. I used a hard plastic picker to remove as much of the corrosion as possible. Also

Also
, I took small pieces of tape and pressed them into the recessed area to remove small pieces of metal that had begun to collect to the magnet preventing a tight connection of the electrical points. When

When
I was no longer able to get good clean points, I found just the MagSafe connector and cord on Amazon for about 10% of the original price! I

I
used buttbut joint crimp connectors and shrink tubes to assemble everything! Now I keep a small piece of gaffers tape over the recessed area to keep metal bits from collecting to the magnet[/quote]magnet

状态:

open

原帖由: scyghost7 ,

文本:

[quote]'''I found a probable cause and solution!''' ''Once I was sure there was no warrantee in affect'' The over heating seems to come from the MagSafe connection shorting out due to corrosion build up. I used a hard plastic picker to remove as much of the corrosion as possible. Also, I took small pieces of tape and pressed them into the recessed area to remove small pieces of metal that had begun to collect to the magnet preventing a tight connection of the electrical points. When I was no longer able to get good clean points, I found just the MagSafe connector and cord on Amazon for about 10% of the original price! I used butt joint crimp connectors and shrink tubes to assemble everything! Now I keep a small piece of gaffers tape over the recessed area to keep metal bits from collecting to the magnet[/quote]

状态:

open