跳转到主内容
帮助

原帖由: John ,

文本:

So I have a Maytag fridge with the same light module.  It is out of warranted a d not a recall even though this part is obviously defective.  However after doing some research it seems to be a result of poor soldering on the board which cracks and certain resisters and the switch on J2 of the board become disconnected.  I reflowed the board using a standard heat gun on normal.  Used it on board on the soldered side (side with LED squares) held heat gun about 1" away and moved the gun quickly over connections for about 40 seconds.  It takes a temp of close to 400 degrees to flow solder again.  Let it cool and viola no more problems and saved 89 to 149 bucks.  Do this first before u buy.  Btw this is the main light module W10515058 LED Light.  Remember to put board on a work table or similar do not hold it while using heat gun and allow to cool before picking up.

状态:

open