当前版本： Errol

标题:

Thermal Pads vs Arctic Silver

文本:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

设备:

PowerBook G4 Aluminum 15" 1-1.5 GHz

状态:

open

已接受的回答:

编辑： David Hodson

标题:

Thermal Pads vs Arctic Silver

文本:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

设备:

状态:

open

原帖由： Errol

标题:

Thermal Pads vs Arctic Silver

文本:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

设备:

Powerbook G4 FW800

状态:

open