当前版本： iRobot

标题:

Power button won't work after wifi & screen replacement

文本:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

设备:

状态:

open

编辑： iRobot

标题:

Power button won't work after wifi & screen replacement

文本:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

设备:

iPad 2 Wi-Fi

状态:

open

编辑： Walter Galan

标题:

Power button won't work after wifi & screen replacement

文本:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

设备:

状态:

open

原帖由： Brian

标题:

Power button won't work after wifi & screen replacement

文本:

So I had to replace the screen and during the process I ripped the wifi antenna. I ordered that and put it in no problem. Now before applying the Adhesive Strips I wanted to make sure everything worked. I tired holding the power button and it won't turn on (yes all the ribbon cables are attached). I plugged it into a power supply and it booted and the digitizer seemed to work ok, but not the power button.  To turn it off I had to unscrew the logic board and lift it from the battery packs.  Any ideas?

设备:

iPad 2 Wi-Fi A1395

状态:

open