当前版本： Xpider

标题:

After swapping digitizer, device won't boot

文本:

Hi all, I recently swapped out the digitizer on a S7560M, and since then, the device is stuck in a boot loop, powers up, goes to logo, reboots.

I have torn down and re-assembled the device to check connections, all appears ok.

Can't get to safe mode or recovery, I'm stuck.

Since this is a fairly new device I can't find any further info. I have repaired many different devices over the years, and have not had an issue like this.

any pointers will be greatly appreciated.

设备:

Samsung Galaxy Ace II x

状态:

open

已接受的回答:

编辑： Sam Goldheart

标题:

After swapping digitizer, device won't boot

文本:

Hi all, I recently swapped out the digitizer on a S7560M, and since then, the device is stuck in a boot loop, powers up, goes to logo, reboots.

I have torn down and re-assembled the device to check connections, all appears ok.

Can't get to safe mode or recovery, I'm stuck.

Since this is a fairly new device I can't find any further info. I have repaired many different devices over the years, and have not had an issue like this.

any pointers will be greatly appreciated.

设备:

状态:

open

原帖由： Xpider

标题:

After swapping digitizer, device won't boot

文本:

Hi all, I recently swapped out the digitizer on a S7560M, and since then, the device is stuck in a boot loop, powers up, goes to logo, reboots.

I have torn down and re-assembled the device to check connections, all appears ok.

Can't get to safe mode or recovery, I'm stuck.

Since this is a fairly new device I can't find any further info. I have repaired many different devices over the years, and have not had an issue like this.

any pointers will be greatly appreciated.

设备:

Samsung Galaxy Ace II x S7560M

状态:

open